board:tricorder: enable omap_gpio clocks

[karo-tx-uboot.git] / include / configs / tricorder.h

diff --git a/include/configs/tricorder.h b/include/configs/tricorder.h
index d57394e55016e7b5f3ec80628e049dc73bc0b49c..a6098615eb6c0afcd0933f6c25aa51d71e1a308c 100644 (file)
--- a/include/configs/tricorder.h
+++ b/include/configs/tricorder.h
@@ -63,6 +63,9 @@
 /* GPIO support */
 #define CONFIG_OMAP_GPIO
 
+/* GPIO banks */
+#define CONFIG_OMAP3_GPIO_2            /* GPIO32..63 are in GPIO bank 2 */
+
 /* LED support */
 #define CONFIG_STATUS_LED
 #define CONFIG_BOARD_SPECIFIC_LED
@@ -98,11 +101,11 @@
 #define CONFIG_DOS_PARTITION
 
 /* I2C */
-#define CONFIG_HARD_I2C
-#define CONFIG_SYS_I2C_SPEED           100000
-#define CONFIG_SYS_I2C_SLAVE           1
-#define CONFIG_DRIVER_OMAP34XX_I2C     1
-#define CONFIG_I2C_MULTI_BUS
+#define CONFIG_SYS_I2C
+#define CONFIG_SYS_OMAP24_I2C_SPEED    100000
+#define CONFIG_SYS_OMAP24_I2C_SLAVE    1
+#define CONFIG_SYS_I2C_OMAP34XX
+ 
 
 /* EEPROM */
 #define CONFIG_SYS_I2C_MULTI_EEPROMS
@@ -134,12 +137,11 @@
 #define CONFIG_SYS_NAND_BASE           NAND_BASE       /* physical address */
                                                        /* to access nand at */
                                                        /* CS0 */
-#define GPMC_NAND_ECC_LP_x16_LAYOUT    1
-
 #define CONFIG_SYS_MAX_NAND_DEVICE     1               /* Max number of NAND */
                                                        /* devices */
-#define CONFIG_NAND_OMAP_BCH8
 #define CONFIG_BCH
+#define CONFIG_SYS_NAND_MAX_OOBFREE    2
+#define CONFIG_SYS_NAND_MAX_ECCPOS     56
 
 /* commands to include */
 #include <config_cmd_default.h>
@@ -374,6 +376,7 @@
 
 #define CONFIG_SYS_NAND_ECCSIZE                512
 #define CONFIG_SYS_NAND_ECCBYTES       13
+#define CONFIG_NAND_OMAP_ECCSCHEME     OMAP_ECC_BCH8_CODE_HW_DETECTION_SW
 
 #define CONFIG_SYS_NAND_U_BOOT_START   CONFIG_SYS_TEXT_BASE