/*
- * $Id: mtd-abi.h,v 1.13 2005/11/07 11:14:56 gleixner Exp $
+ * Copyright © 1999-2010 David Woodhouse <dwmw2@infradead.org> et al.
+ *
+ * SPDX-License-Identifier: GPL-2.0+
*
- * Portions of MTD ABI definition which are shared by kernel and user space
*/
#ifndef __MTD_ABI_H__
#define __MTD_ABI_H__
-#if 1
+#define __UBOOT__
+#ifdef __UBOOT__
#include <linux/compat.h>
#endif
#include <linux/compiler.h>
struct erase_info_user {
- uint32_t start;
- uint32_t length;
+ __u32 start;
+ __u32 length;
+};
+
+struct erase_info_user64 {
+ __u64 start;
+ __u64 length;
};
struct mtd_oob_buf {
- uint32_t start;
- uint32_t length;
+ __u32 start;
+ __u32 length;
unsigned char __user *ptr;
};
-/*
+struct mtd_oob_buf64 {
+ __u64 start;
+ __u32 pad;
+ __u32 length;
+ __u64 usr_ptr;
+};
+
+/**
* MTD operation modes
*
* @MTD_OPS_PLACE_OOB: OOB data are placed at the given offset (default)
MTD_OPS_RAW = 2,
};
+/**
+ * struct mtd_write_req - data structure for requesting a write operation
+ *
+ * @start: start address
+ * @len: length of data buffer
+ * @ooblen: length of OOB buffer
+ * @usr_data: user-provided data buffer
+ * @usr_oob: user-provided OOB buffer
+ * @mode: MTD mode (see "MTD operation modes")
+ * @padding: reserved, must be set to 0
+ *
+ * This structure supports ioctl(MEMWRITE) operations, allowing data and/or OOB
+ * writes in various modes. To write to OOB-only, set @usr_data == NULL, and to
+ * write data-only, set @usr_oob == NULL. However, setting both @usr_data and
+ * @usr_oob to NULL is not allowed.
+ */
+struct mtd_write_req {
+ __u64 start;
+ __u64 len;
+ __u64 ooblen;
+ __u64 usr_data;
+ __u64 usr_oob;
+ __u8 mode;
+ __u8 padding[7];
+};
+
#define MTD_ABSENT 0
#define MTD_RAM 1
#define MTD_ROM 2
#define MTD_NORFLASH 3
-#define MTD_NANDFLASH 4
+#define MTD_NANDFLASH 4 /* SLC NAND */
#define MTD_DATAFLASH 6
#define MTD_UBIVOLUME 7
+#define MTD_MLCNANDFLASH 8 /* MLC NAND (including TLC) */
#define MTD_WRITEABLE 0x400 /* Device is writeable */
#define MTD_BIT_WRITEABLE 0x800 /* Single bits can be flipped */
#define MTD_NO_ERASE 0x1000 /* No erase necessary */
-#define MTD_STUPID_LOCK 0x2000 /* Always locked after reset */
+#define MTD_POWERUP_LOCK 0x2000 /* Always locked after reset */
/* Some common devices / combinations of capabilities */
#define MTD_CAP_ROM 0
#define MTD_CAP_NORFLASH (MTD_WRITEABLE | MTD_BIT_WRITEABLE)
#define MTD_CAP_NANDFLASH (MTD_WRITEABLE)
-/* ECC byte placement */
-#define MTD_NANDECC_OFF 0 /* Switch off ECC (Not recommended) */
-#define MTD_NANDECC_PLACE 1 /* Use the given placement in the structure (YAFFS1 legacy mode) */
-#define MTD_NANDECC_AUTOPLACE 2 /* Use the default placement scheme */
-#define MTD_NANDECC_PLACEONLY 3 /* Use the given placement in the structure (Do not store ecc result on read) */
-#define MTD_NANDECC_AUTOPL_USR 4 /* Use the given autoplacement scheme rather than using the default */
+/* Obsolete ECC byte placement modes (used with obsolete MEMGETOOBSEL) */
+#define MTD_NANDECC_OFF 0 // Switch off ECC (Not recommended)
+#define MTD_NANDECC_PLACE 1 // Use the given placement in the structure (YAFFS1 legacy mode)
+#define MTD_NANDECC_AUTOPLACE 2 // Use the default placement scheme
+#define MTD_NANDECC_PLACEONLY 3 // Use the given placement in the structure (Do not store ecc result on read)
+#define MTD_NANDECC_AUTOPL_USR 4 // Use the given autoplacement scheme rather than using the default
/* OTP mode selection */
#define MTD_OTP_OFF 0
#define MTD_OTP_USER 2
struct mtd_info_user {
- uint8_t type;
- uint32_t flags;
- uint32_t size; /* Total size of the MTD */
- uint32_t erasesize;
- uint32_t writesize;
- uint32_t oobsize; /* Amount of OOB data per block (e.g. 16) */
- /* The below two fields are obsolete and broken, do not use them
- * (TODO: remove at some point) */
- uint32_t ecctype;
- uint32_t eccsize;
+ __u8 type;
+ __u32 flags;
+ __u32 size; /* Total size of the MTD */
+ __u32 erasesize;
+ __u32 writesize;
+ __u32 oobsize; /* Amount of OOB data per block (e.g. 16) */
+ __u64 padding; /* Old obsolete field; do not use */
};
struct region_info_user {
- uint32_t offset; /* At which this region starts,
- * from the beginning of the MTD */
- uint32_t erasesize; /* For this region */
- uint32_t numblocks; /* Number of blocks in this region */
- uint32_t regionindex;
+ __u32 offset; /* At which this region starts,
+ * from the beginning of the MTD */
+ __u32 erasesize; /* For this region */
+ __u32 numblocks; /* Number of blocks in this region */
+ __u32 regionindex;
};
struct otp_info {
- uint32_t start;
- uint32_t length;
- uint32_t locked;
+ __u32 start;
+ __u32 length;
+ __u32 locked;
};
+/*
+ * Note, the following ioctl existed in the past and was removed:
+ * #define MEMSETOOBSEL _IOW('M', 9, struct nand_oobinfo)
+ * Try to avoid adding a new ioctl with the same ioctl number.
+ */
+
/* Get basic MTD characteristics info (better to use sysfs) */
#define MEMGETINFO _IOR('M', 1, struct mtd_info_user)
/* Erase segment of MTD */
/* Get information about the erase region for a specific index */
#define MEMGETREGIONINFO _IOWR('M', 8, struct region_info_user)
/* Get info about OOB modes (e.g., RAW, PLACE, AUTO) - legacy interface */
-#define MEMSETOOBSEL _IOW('M', 9, struct nand_oobinfo)
#define MEMGETOOBSEL _IOR('M', 10, struct nand_oobinfo)
/* Check if an eraseblock is bad */
-#define MEMGETBADBLOCK _IOW('M', 11, loff_t)
+#define MEMGETBADBLOCK _IOW('M', 11, __kernel_loff_t)
/* Mark an eraseblock as bad */
-#define MEMSETBADBLOCK _IOW('M', 12, loff_t)
+#define MEMSETBADBLOCK _IOW('M', 12, __kernel_loff_t)
/* Set OTP (One-Time Programmable) mode (factory vs. user) */
#define OTPSELECT _IOR('M', 13, int)
/* Get number of OTP (One-Time Programmable) regions */
/* Lock a given range of user data (must be in mode %MTD_FILE_MODE_OTP_USER) */
#define OTPLOCK _IOR('M', 16, struct otp_info)
/* Get ECC layout (deprecated) */
-#define ECCGETLAYOUT _IOR('M', 17, struct nand_ecclayout)
+#define ECCGETLAYOUT _IOR('M', 17, struct nand_ecclayout_user)
/* Get statistics about corrected/uncorrected errors */
#define ECCGETSTATS _IOR('M', 18, struct mtd_ecc_stats)
/* Set MTD mode on a per-file-descriptor basis (see "MTD file modes") */
#define MTDFILEMODE _IO('M', 19)
+/* Erase segment of MTD (supports 64-bit address) */
+#define MEMERASE64 _IOW('M', 20, struct erase_info_user64)
+/* Write data to OOB (64-bit version) */
+#define MEMWRITEOOB64 _IOWR('M', 21, struct mtd_oob_buf64)
+/* Read data from OOB (64-bit version) */
+#define MEMREADOOB64 _IOWR('M', 22, struct mtd_oob_buf64)
+/* Check if chip is locked (for MTD that supports it) */
+#define MEMISLOCKED _IOR('M', 23, struct erase_info_user)
+/*
+ * Most generic write interface; can write in-band and/or out-of-band in various
+ * modes (see "struct mtd_write_req"). This ioctl is not supported for flashes
+ * without OOB, e.g., NOR flash.
+ */
+#define MEMWRITE _IOWR('M', 24, struct mtd_write_req)
/*
* Obsolete legacy interface. Keep it in order not to break userspace
* interfaces
*/
struct nand_oobinfo {
- uint32_t useecc;
- uint32_t eccbytes;
- uint32_t oobfree[8][2];
- uint32_t eccpos[48];
+ __u32 useecc;
+ __u32 eccbytes;
+ __u32 oobfree[8][2];
+ __u32 eccpos[32];
};
struct nand_oobfree {
- uint32_t offset;
- uint32_t length;
+ __u32 offset;
+ __u32 length;
};
#define MTD_MAX_OOBFREE_ENTRIES 8
+#define MTD_MAX_ECCPOS_ENTRIES 64
/*
- * ECC layout control structure. Exported to userspace for
- * diagnosis and to allow creation of raw images
+ * OBSOLETE: ECC layout control structure. Exported to user-space via ioctl
+ * ECCGETLAYOUT for backwards compatbility and should not be mistaken as a
+ * complete set of ECC information. The ioctl truncates the larger internal
+ * structure to retain binary compatibility with the static declaration of the
+ * ioctl. Note that the "MTD_MAX_..._ENTRIES" macros represent the max size of
+ * the user struct, not the MAX size of the internal struct nand_ecclayout.
*/
-struct nand_ecclayout {
- uint32_t eccbytes;
- uint32_t eccpos[128];
- uint32_t oobavail;
+struct nand_ecclayout_user {
+ __u32 eccbytes;
+ __u32 eccpos[MTD_MAX_ECCPOS_ENTRIES];
+ __u32 oobavail;
struct nand_oobfree oobfree[MTD_MAX_OOBFREE_ENTRIES];
};
* @bbtblocks: number of blocks reserved for bad block tables
*/
struct mtd_ecc_stats {
- uint32_t corrected;
- uint32_t failed;
- uint32_t badblocks;
- uint32_t bbtblocks;
+ __u32 corrected;
+ __u32 failed;
+ __u32 badblocks;
+ __u32 bbtblocks;
};
/*
* used out of necessity (e.g., `write()', ioctl(MEMWRITEOOB64)).
*/
enum mtd_file_modes {
- MTD_MODE_NORMAL = MTD_OTP_OFF,
- MTD_MODE_OTP_FACTORY = MTD_OTP_FACTORY,
- MTD_MODE_OTP_USER = MTD_OTP_USER,
- MTD_MODE_RAW,
+ MTD_FILE_MODE_NORMAL = MTD_OTP_OFF,
+ MTD_FILE_MODE_OTP_FACTORY = MTD_OTP_FACTORY,
+ MTD_FILE_MODE_OTP_USER = MTD_OTP_USER,
+ MTD_FILE_MODE_RAW,
};
+static inline int mtd_type_is_nand_user(const struct mtd_info_user *mtd)
+{
+ return mtd->type == MTD_NANDFLASH || mtd->type == MTD_MLCNANDFLASH;
+}
+
#endif /* __MTD_ABI_H__ */
projects / karo-tx-uboot.git / blobdiff