#include <nand.h>
#include <onenand_uboot.h>
#include <mmc.h>
+#include <asm/sections.h>
DECLARE_GLOBAL_DATA_PTR;
memset((void *)gd, 0, GENERATED_GBL_DATA_SIZE);
- gd->mon_len = (unsigned int)(&__bss_end__) - (unsigned int)(&_start);
+ gd->mon_len = (unsigned int)(&__bss_end) - (unsigned int)(&_start);
for (init_fnc_ptr = init_sequence; *init_fnc_ptr; ++init_fnc_ptr) {
if ((*init_fnc_ptr)() != 0)
addr = CONFIG_SYS_SDRAM_BASE + gd->ram_size;
-#if !(defined(CONFIG_SYS_ICACHE_OFF) && defined(CONFIG_SYS_DCACHE_OFF))
- /* reserve TLB table */
- addr -= (4096 * 4);
-
- /* round down to next 64 kB limit */
- addr &= ~(0x10000 - 1);
-
- gd->tlb_addr = addr;
- debug("TLB table at: %08lx\n", addr);
-#endif
-
/* round down to next 4 kB limit */
addr &= ~(4096 - 1);
debug("Top of RAM usable for U-Boot at: %08lx\n", addr);
gd->flags |= GD_FLG_RELOC; /* tell others: relocation done */
- monitor_flash_len = &_end - &_start;
+ monitor_flash_len = (ulong)&_end - (ulong)&_start;
debug("monitor flash len: %08lX\n", monitor_flash_len);
board_init(); /* Setup chipselects */
/* The Malloc area is immediately below the monitor copy in DRAM */
malloc_start = dest_addr - TOTAL_MALLOC_LEN;
mem_malloc_init(malloc_start, TOTAL_MALLOC_LEN);
- malloc_bin_reloc();
#ifndef CONFIG_SYS_NO_FLASH
/* configure available FLASH banks */
/* NOTREACHED - no way out of command loop except booting */
}
-
-void hang(void)
-{
- puts("### ERROR ### Please RESET the board ###\n");
- for (;;)
- ;
-}