gpio: use appropriate return values for cmd handler

[karo-tx-uboot.git] / configs / Ippo_q8h_v1_2_defconfig

diff --git a/configs/Ippo_q8h_v1_2_defconfig b/configs/Ippo_q8h_v1_2_defconfig
index d9455c8f35cceb7b15d6d0a61c5242a96388719b..5b49c446ed66aebab76ac2e8037beb2e0dc1f421 100644 (file)
--- a/configs/Ippo_q8h_v1_2_defconfig
+++ b/configs/Ippo_q8h_v1_2_defconfig
@@ -1,21 +1,24 @@
-CONFIG_SPL=y
-CONFIG_SYS_EXTRA_OPTIONS="CONS_INDEX=5"
-CONFIG_FDTFILE="sun8i-a23-ippo-q8h-v1.2.dtb"
-CONFIG_USB_MUSB_SUNXI=y
+CONFIG_ARM=y
+CONFIG_ARCH_SUNXI=y
+CONFIG_MACH_SUN8I_A23=y
+CONFIG_DRAM_CLK=432
+CONFIG_DRAM_ZQ=63306
 CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
 CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
+CONFIG_USB0_ID_DET="PH8"
+CONFIG_AXP_GPIO=y
 CONFIG_VIDEO_LCD_MODE="x:800,y:480,depth:18,pclk_khz:33000,le:87,ri:167,up:31,lo:13,hs:1,vs:1,sync:3,vmode:0"
 CONFIG_VIDEO_LCD_DCLK_PHASE=0
 CONFIG_VIDEO_LCD_POWER="PH7"
 CONFIG_VIDEO_LCD_BL_EN="PH6"
 CONFIG_VIDEO_LCD_BL_PWM="PH0"
-CONFIG_ARM=y
-CONFIG_ARCH_SUNXI=y
-CONFIG_MACH_SUN8I_A23=y
-CONFIG_DRAM_CLK=432
-# zq = 0xf74a
-CONFIG_DRAM_ZQ=63306
-# Wifi power
+CONFIG_DEFAULT_DEVICE_TREE="sun8i-a23-ippo-q8h-v1.2"
+# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+CONFIG_SPL=y
+CONFIG_SYS_EXTRA_OPTIONS="CONS_INDEX=5"
+# CONFIG_CMD_IMLS is not set
+# CONFIG_CMD_FLASH is not set
+# CONFIG_CMD_FPGA is not set
 CONFIG_AXP221_DLDO1_VOLT=3300
-# aldo1 is connected to VCC-IO, VCC-PD, VCC-USB and VCC-HP
 CONFIG_AXP221_ALDO1_VOLT=3000
+CONFIG_USB_MUSB_HOST=y