gpio: mxs: fix prototype of gpio_set_value()

[karo-tx-uboot.git] / doc / README.fdt-control

diff --git a/doc/README.fdt-control b/doc/README.fdt-control
index 0ceebe7aa6f959fb901a21a45931ee245836eac7..d8fe4a826f20d41335067b6c3a251d1a12d4dfd8 100644 (file)
--- a/doc/README.fdt-control
+++ b/doc/README.fdt-control
@@ -122,7 +122,8 @@ This should include your CPU or SOC's device tree file, placed in
 arch/<arch>/dts, and then make any adjustments required.
 
 If CONFIG_OF_EMBED is defined, then it will be picked up and built into
-the U-Boot image (including u-boot.bin).
+the U-Boot image (including u-boot.bin). This is suitable for debugging
+and development only and is not recommended for production devices.
 
 If CONFIG_OF_SEPARATE is defined, then it will be built and placed in
 a u-boot.dtb file alongside u-boot.bin. A common approach is then to
@@ -130,7 +131,10 @@ join the two:
 
        cat u-boot.bin u-boot.dtb >image.bin
 
-and then flash image.bin onto your board.
+and then flash image.bin onto your board. Note that U-Boot creates
+u-boot-dtb.bin which does the above step for you also. If you are using
+CONFIG_SPL_FRAMEWORK, then u-boot.img will be built to include the device
+tree binary.
 
 If CONFIG_OF_HOSTFILE is defined, then it will be read from a file on
 startup. This is only useful for sandbox. Use the -d flag to U-Boot to
@@ -138,6 +142,14 @@ specify the file to read.
 
 You cannot use more than one of these options at the same time.
 
+To use a device tree file that you have compiled yourself, pass
+EXT_DTB=<filename> to 'make', as in:
+
+       make EXT_DTB=boot/am335x-boneblack-pubkey.dtb
+
+Then U-Boot will copy that file to u-boot.dtb, put it in the .img file
+if used, and u-boot-dtb.bin.
+
 If you wish to put the fdt at a different address in memory, you can
 define the "fdtcontroladdr" environment variable. This is the hex
 address of the fdt binary blob, and will override either of the options.