lcd: fix integer overflow in calculation of number of colors

[karo-tx-uboot.git] / doc / README.nand

diff --git a/doc/README.nand b/doc/README.nand
index 46d7edd179f139bb9688bfe1557bd5cbbcc53daf..0ff56331d5f92ec1ba0dbea186e40d36b4a06cb2 100644 (file)
--- a/doc/README.nand
+++ b/doc/README.nand
@@ -188,24 +188,6 @@ Configuration Options:
        This is used by SoC platforms which do not have built-in ELM
        hardware engine required for BCH ECC correction.
 
-   CONFIG_SYS_NAND_BUSWIDTH_16BIT
-       Indicates that NAND device has 16-bit wide data-bus. In absence of this
-       config, bus-width of NAND device is assumed to be either 8-bit and later
-       determined by reading ONFI params.
-       Above config is useful when NAND device's bus-width information cannot
-       be determined from on-chip ONFI params, like in following scenarios:
-       - SPL boot does not support reading of ONFI parameters. This is done to
-         keep SPL code foot-print small.
-       - In current U-Boot flow using nand_init(), driver initialization
-         happens in board_nand_init() which is called before any device probe
-         (nand_scan_ident + nand_scan_tail), thus device's ONFI parameters are
-         not available while configuring controller. So a static CONFIG_NAND_xx
-         is needed to know the device's bus-width in advance.
-       Some drivers using above config are:
-       drivers/mtd/nand/mxc_nand.c
-       drivers/mtd/nand/ndfc.c
-       drivers/mtd/nand/omap_gpmc.c
-
 
 Platform specific options
 =========================