Unified codebase for TX28, TX48, TX51, TX53

[karo-tx-uboot.git] / include / configs / mx28evk.h

diff --git a/include/configs/mx28evk.h b/include/configs/mx28evk.h
index 8a752aa2a484008e7d85d18eb3379e79d4470f12..0c18e5022a142e98e2e1e5510cf5bdf5e3aaa699 100644 (file)
--- a/include/configs/mx28evk.h
+++ b/include/configs/mx28evk.h
@@ -46,6 +46,7 @@
 #define CONFIG_SPL_LDSCRIPT    "arch/arm/cpu/arm926ejs/mx28/u-boot-spl.lds"
 #define CONFIG_SPL_LIBCOMMON_SUPPORT
 #define CONFIG_SPL_LIBGENERIC_SUPPORT
+#define CONFIG_SPL_GPIO_SUPPORT
 
 /*
  * U-Boot Commands
@@ -64,6 +65,10 @@
 #define CONFIG_CMD_NET
 #define CONFIG_CMD_NFS
 #define CONFIG_CMD_PING
+#define CONFIG_CMD_SF
+#define CONFIG_CMD_SPI
+#define CONFIG_CMD_USB
+#define CONFIG_CMD_BOOTZ
 
 /*
  * Memory configurations
@@ -78,7 +83,7 @@
 #define CONFIG_SYS_SDRAM_BASE          PHYS_SDRAM_1
 /* Point initial SP in SRAM so SPL can use it too. */
 
-#define CONFIG_SYS_INIT_RAM_ADDR       0x00002000
+#define CONFIG_SYS_INIT_RAM_ADDR       0x00000000
 #define CONFIG_SYS_INIT_RAM_SIZE       (128 * 1024)
 
 #define CONFIG_SYS_INIT_SP_OFFSET \
@@ -122,20 +127,38 @@
 #define CONFIG_BAUDRATE                        115200  /* Default baud rate */
 #define CONFIG_SYS_BAUDRATE_TABLE      { 9600, 19200, 38400, 57600, 115200 }
 
+/*
+ * DMA
+ */
+#define CONFIG_APBH_DMA
+
 /*
  * MMC Driver
  */
 #define CONFIG_ENV_IS_IN_MMC
-#define CONFIG_ENV_OFFSET      (256 * 1024)
-#define CONFIG_ENV_SIZE        (16 * 1024)
-#define CONFIG_SYS_MMC_ENV_DEV 0
+#ifdef CONFIG_ENV_IS_IN_MMC
+ #define CONFIG_ENV_OFFSET     (256 * 1024)
+ #define CONFIG_ENV_SIZE       (16 * 1024)
+ #define CONFIG_SYS_MMC_ENV_DEV 0
+#endif
 #define CONFIG_CMD_SAVEENV
 #ifdef CONFIG_CMD_MMC
 #define CONFIG_MMC
 #define CONFIG_GENERIC_MMC
+#define CONFIG_MMC_BOUNCE_BUFFER
 #define CONFIG_MXS_MMC
 #endif
 
+/*
+ * NAND Driver
+ */
+#ifdef CONFIG_CMD_NAND
+#define CONFIG_NAND_MXS
+#define CONFIG_SYS_MAX_NAND_DEVICE     1
+#define CONFIG_SYS_NAND_BASE           0x60000000
+#define CONFIG_SYS_NAND_5_ADDR_CYCLE
+#endif
+
 /*
  * Ethernet on SOC (FEC)
  */
@@ -157,6 +180,53 @@
 #define        CONFIG_RTC_MXS
 #endif
 
+/*
+ * USB
+ */
+#ifdef CONFIG_CMD_USB
+#define        CONFIG_USB_EHCI
+#define        CONFIG_USB_EHCI_MXS
+#define        CONFIG_EHCI_MXS_PORT 1
+#define        CONFIG_EHCI_IS_TDI
+#define        CONFIG_USB_STORAGE
+#endif
+
+/*
+ * SPI
+ */
+#ifdef CONFIG_CMD_SPI
+#define CONFIG_HARD_SPI
+#define CONFIG_MXS_SPI
+#define CONFIG_SPI_HALF_DUPLEX
+#define CONFIG_DEFAULT_SPI_BUS         2
+#define CONFIG_DEFAULT_SPI_MODE                SPI_MODE_0
+
+/* SPI Flash */
+#ifdef CONFIG_CMD_SF
+#define CONFIG_SPI_FLASH
+#define CONFIG_SF_DEFAULT_BUS  2
+#define CONFIG_SF_DEFAULT_CS   0
+/* this may vary and depends on the installed chip */
+#define CONFIG_SPI_FLASH_SST
+#define CONFIG_SF_DEFAULT_MODE         SPI_MODE_0
+#define CONFIG_SF_DEFAULT_SPEED                24000000
+
+/* (redundant) environemnt in SPI flash */
+#undef CONFIG_ENV_IS_IN_SPI_FLASH
+#ifdef CONFIG_ENV_IS_IN_SPI_FLASH
+#define CONFIG_SYS_REDUNDAND_ENVIRONMENT
+#define CONFIG_ENV_SIZE                        0x1000          /* 4KB */
+#define CONFIG_ENV_OFFSET              0x40000         /* 256K */
+#define CONFIG_ENV_OFFSET_REDUND       (CONFIG_ENV_OFFSET + CONFIG_ENV_SIZE)
+#define CONFIG_ENV_SECT_SIZE           0x1000
+#define CONFIG_ENV_SPI_CS              0
+#define CONFIG_ENV_SPI_BUS             2
+#define CONFIG_ENV_SPI_MAX_HZ          24000000
+#define CONFIG_ENV_SPI_MODE            SPI_MODE_0
+#endif
+#endif
+#endif
+
 /*
  * Boot Linux
  */
@@ -167,6 +237,7 @@
 #define CONFIG_BOOTCOMMAND     "run bootcmd_net"
 #define CONFIG_LOADADDR        0x42000000
 #define CONFIG_SYS_LOAD_ADDR   CONFIG_LOADADDR
+#define CONFIG_OF_LIBFDT
 
 /*
  * Extra Environments