arm/rpi: Enable dcache

[karo-tx-uboot.git] / include / configs / socfpga_cyclone5.h

diff --git a/include/configs/socfpga_cyclone5.h b/include/configs/socfpga_cyclone5.h
index a78084e260e1d99ce3a912beb33ec680637c0539..192cda7c9abfb97fc65f36e73152418ac2582b8c 100644 (file)
--- a/include/configs/socfpga_cyclone5.h
+++ b/include/configs/socfpga_cyclone5.h
@@ -5,13 +5,9 @@
  */
 
 #include <asm/arch/socfpga_base_addrs.h>
-#include "../../board/altera/socfpga/pinmux_config.h"
-#include "../../board/altera/socfpga/iocsr_config.h"
-#include "../../board/altera/socfpga/pll_config.h"
 
 /* U-Boot Commands */
 #define CONFIG_SYS_NO_FLASH
-#include <config_cmd_default.h>
 #define CONFIG_DOS_PARTITION
 #define CONFIG_FAT_WRITE
 #define CONFIG_HW_WATCHDOG
@@ -24,14 +20,11 @@
 #define CONFIG_CMD_EXT4
 #define CONFIG_CMD_EXT4_WRITE
 #define CONFIG_CMD_FAT
-#define CONFIG_CMD_FPGA
 #define CONFIG_CMD_FS_GENERIC
 #define CONFIG_CMD_GREPENV
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_MMC
-#define CONFIG_CMD_NET
 #define CONFIG_CMD_PING
-#define CONFIG_CMD_SETEXPR
 #define CONFIG_CMD_USB
 #define CONFIG_CMD_USB_MASS_STORAGE
 
@@ -47,13 +40,11 @@
 #else
 #define CONFIG_BOOTCOMMAND     "run mmcload; run mmcboot"
 #endif
-#define CONFIG_LOADADDR                0x8000
+#define CONFIG_LOADADDR                0x01000000
 #define CONFIG_SYS_LOAD_ADDR   CONFIG_LOADADDR
 
 /* Ethernet on SoC (EMAC) */
 #if defined(CONFIG_CMD_NET)
-#define CONFIG_EMAC_BASE               SOCFPGA_EMAC1_ADDRESS
-#define CONFIG_PHY_INTERFACE_MODE      PHY_INTERFACE_MODE_RGMII
 
 /* PHY */
 #define CONFIG_PHY_MICREL