Add default switch settings.

diff --git a/doc/README.Purple b/doc/README.Purple
index 9e70004ae4faf8e5daeb4e63dcd3cb341538f496..c05e0ff3633a15f49599362edaf05401d765e248 100644 (file)
--- a/doc/README.Purple
+++ b/doc/README.Purple
@@ -11,6 +11,20 @@ Installation Instructions:
        |   X|  
        ------
 
+   Put the s3 switch into the following position:
+
+       1   0
+       ------
+       |x   |
+       |x   |
+       |x   |  
+       |x   |
+       |x   |
+       |   x|
+       |   x|
+       |x   |  
+       ------
+
 2. Connect to the serial console and to the BDI. Power on. On the
    serial line, you should see:
 
@@ -34,8 +48,17 @@ Installation Instructions:
 
        prog 0xB0000000 <u-boot.bin> bin
 
-6. Power off. Restore the original S2 switch position. Power on.
-   U-Boot should come up.
+6. Power off. Restore the original S2 switch position:
+
+        1  0
+       ------
+       |   x|
+       |   x|
+       |x   |  
+       |   X|  
+       ------
+
+   Power on.  U-Boot should come up.
 
 
 
@@ -48,5 +71,5 @@ can't really check whether 'erase' is complete by polling flash as it
 is usually done. Instead, the flash driver simply waits for a given
 time and assumes that erase then has passed. This behaviour is
 identical to what the VxWorks driver does; also, the same timeout (6
-seconds) was chosen. Note that this timeout applies for each errase
+seconds) was chosen. Note that this timeout applies for each erase
 operation, i. e. per erased sector.